PubNub & Raspberry Pi: Up and Running

This tutorial was originally published on rexstjohn.com. Rex St John is a mobile software engineer living in Seattle’s Capitol Hill neighborhood who has worked on a wide variety of enterprise and consumer mobile applications including touch walls, games, mobile sales tools and more.

raspberry pi

What follows is a tutorial outlining how to get up and running with PubNub on a Raspberry Pi running Raspbian. I have created this tutorial to walk through the process of getting up and running with PubNub for the purpose of connected device / embedded device demonstrations at the upcoming Wearable Computing AT&T Hackathon.

Step 1: Have a Raspberry Pi configured and running Raspbian

This should be relatively straightforward, your OS does not honestly have to be Raspbian but that is what I am using to go through this process. More than likely any common Linux distribution will be fine.

In my case I ordered a basic Raspberry Pi development kit which comes complete with an HDMI cable, an SD card, a mini-usb power supply and a plastic shell to keep you from shorting out the motherboard.

You will need to have a PubNub account…logged in and activated as a developer (free!).

Also make sure you have (obviously) some type of internet connection whether it be a WiFi Nub or ethernet cable. Assuming your Pi is plugged in, turned on and connected to the internet…proceed from there.

raspberry piStep 2: Clone into the PubNub C-Library GitHub Account

Create and navigate to a folder on your Desktop or other such desired location in the terminal. Much of this information can already be found on the GitHub page for the Raspberry Pi C client for PubNub here: https://github.com/pubnub/c.

On your standard command line run:

You will also need to run the following commands to install the libraries necessary to “make” or build the PubNub C libary

Next, browse to your “C” folder which you just cloned from GitHub where the PubNub C libraries now should reside

Step 3: Test Your Pub / Sub Connection

Time to try a publish / subscribe communication between your Pi and PubNub.

Open example-sync-demo.c with your favorite editor

Now change the following lines to match your PubNub pub / sub credentials. These credentials should be on your PubNub API dashboard:

raspberry pi

Replace the demo publish and subscribe tags below with your actual credentials in the example-sync-demo.c file.

Next, customize your message which you are publishing to something you will recognize (line 27):

Next, you will need to build a “.o” file by running “make” while in the examples directory. The result should be example-sync-demo.o.

Run this file in the terminal with: ./example-sync-demo

You should see the following:

Trackbacks/Pingbacks

mBed, Arduino, Raspberry Pi & PubNub Links – Rex St John

Get Started
Sign up for free and use PubNub to power remote IoT signaling

Try PubNub Today

Connect up to 100 devices for Free
Get Started with PubNub Realtime Data Stream Network
Loading...